FAQ: How To Recondition Golf Clubs?

FAQ: How To Recondition Golf Clubs?

How much does it cost to refurbish golf clubs?

Pricing

Club Customization 1 Club 9 Clubs
Install Grip* + Alter Length $5.00 $37.00
Install Grip* + Wraps + Alter Length $6.00 $45.00
Alter Lie Angle $4.00 $30.00
Refurbish Iron** $15.00 $112.00

2

Can you Rechrome golf clubs?

I would not recommend chroming your golf clubs, especially if it’s the reflective finish you ‘re after that’s always associated with chrome. The reason is that every swing you take, off of the fairway, rough, or especially out of the sand trap will scratch the chrome.

How do you clean and restore golf clubs?

If the clubs are particularly dirty, soak them in a bucket of water with mild soap to help loosen the debris. Use a piece of steel wool to begin removing the rust from your golf clubs. You don’t need to apply a lot of force. The wires of the steel wool will provide enough friction to scrub away the rust.

Is a 2 iron worth it?

Believe it or not, some golfers are not able to effectively use a 2 – iron. As a general rule of thumb, if your stock 7- iron goes any less than 150 yards, a 2 – iron is out of the picture. For those who don’t “qualify” for a 2 – iron, a viable alternative could be a hybrid iron, hybrid, or 5 wood.

You might be interested:  Question: What Are The Average Distances For Golf Clubs?

How do I make my golf clubs shine like new?

Take a wet towel with a little dab of dish soap on it, and clean your golf club grip. Rinse with a clean wet cloth. Dry your club and club grip with a new clean dry cloth. Optionally, you can use some chrome polish or metal polish to polish the golf club shaft and face to help protect against rust.

How much does it cost to Rechrome golf clubs?

Iron and Wedge Services Pricing Table

Service Price
Plating Finish (Chrome, Copper) A single club head – $115, 2 club heads – $95 per head, 3 or more club heads – $65 per head paint fill is included
BOS Finishes A single club head – $95, 2 club heads – $75 per head, 3 or more club heads – $65 per headpaint fill is included

5

Can you use WD40 on golf clubs?

When you find that your clubs have a bit of rust on them, you can use WD40 to get it off. Remove the golf clubs from the bag; if you spray WD40 on your bag, it will smell for a long time. Spray the WD40 on your irons and wedges and let it sit for a few minutes. Take a dry cloth and wipe the WD40 off the clubs.

How do I make my golf clubs look new?

Apply any metal polish or car wheel polish to the golf clubs. Most polishes can be applied with a soft cloth or towel. Let them sit for a minute, then wipe the polish from the clubs. Spray polishes are also available.

You might be interested:  Quick Answer: Which Package To Use For Golf Clubs?

What is the best cleaner for golf clubs?

Mix warm water and 2 teaspoons of dishwashing liquid or soap into a bowl or a bucket (depending on how many clubs you need to clean). Dip your soft-bristle brush or toothbrush into the mixture and carefully scrub your club head, making sure that it doesn’t get too wet.

Does WD-40 Remove rust?

WD – 40 Specialist® Rust Remover Soak quickly dissolves rust and restores tools, equipment, and surfaces to bare metal without chipping, scraping or scrubbing. Great for removing rust from tools, metal, cast iron, chrome parts, and more without harming paint, gaskets, trim, or other surrounding parts.

How do you keep your golf clubs from rusting?

How to Prevent Golf Clubs From Rusting

  1. Dry the head, shaft and grip of each golf club with your golf towel immediately after using the club.
  2. Check the condition of your clubs upon arriving home following your round of play and dry any areas that remain wet.
  3. Store your clubs in an area of your home that is not humid.

Leave a Reply

Your email address will not be published. Required fields are marked *